Freight brokerage TMS · Billing
Broker credit check: customer credit limits and holds
Set a credit limit on each customer in Companies. When you book, Tezify compares the new order with what the customer already owes you plus booked loads not yet invoiced. Turn on the hold to refuse orders over the limit, and set a past-due hold on Invoicing.
What the credit check is, and what it is not
As a broker you pay the carrier whether or not the shipper pays you. Every load you book for a customer is credit you extend. The Tezify credit check measures that from your own books. It does not pull a credit bureau report or a third-party days-to-pay score. For a new shipper, run that kind of check outside Tezify before you set the limit, and keep the result in the customer's documents.
How credit used is worked out
- Unpaid invoices: what your AR aging says the customer owes.
- Plus booked loads not invoiced yet, including billable extras such as detention.
- Brokerage loads and invoices only. If you also run trucks, carrier-side freight for the same customer does not count.
- The new order's rate, fuel surcharge and charges are added on top before the limit is compared.
Set it up
- Open Companies, edit the customer and enter the Credit limit and Payment terms.
- As the owner, open More on the Desk and turn on Hold orders over a customer's credit limit.
- On Invoicing, in Collections, fill in Hold a customer when an invoice is more than a number of days past due, and save. Zero means off, which is the default.
- In the same list, set one customer to Hold by hand, or release a customer the rule put on hold.
What happens at booking
- The order form shows credit used against the limit.
- With the hold on, an order over the limit is refused. With it off, it books with a warning.
- A customer on hold can only be booked by the owner, who ticks Book anyway and writes why. The reason is logged.
- Repeats, duplicates and recurring orders run the same check, and changing the customer on an order runs the new customer's check.
- On the load page, the credit line turns amber close to the limit and red when it is over.
A manual release ends when the customer gets a new past-due invoice. Collections shows the release ended and why.
Common mistakes
- Setting a limit and leaving the hold off. You get warnings, but orders still book.
- Two Companies records for one shipper. The check cannot tell which limit applies and refuses the order until there is one record.
- Releasing a hold without collecting. The next past-due invoice puts the customer back on hold.
Common questions
Does Tezify run a credit report on my shipper?
No. It checks what the customer owes you and what you have booked for them against the limit you set. Use your own credit source to choose that limit.
What about a new customer with no invoices yet?
Their aging reads as zero, so only booked loads count. If they are not in Companies, there is no limit to compare against and the form says so.
Can a dispatcher book a customer on hold?
No. Only the owner can, with a written reason.
I also haul freight. Can Tezify check a broker who wants to pay me?
Yes, on the carrier side. The New load form reads your history with that payer: never hauled for them, slow pay past 45 days, money already owed, or a rate far above your usual. It does not check bonds or credit reports.
Ready to do it? This lives at /admin/companies in Tezify.
Related articles
- Freight brokerage TMSLogistics CRM: add shippers with billing terms and credit
- Freight brokerage TMSHow to run collections and send payment reminders
- Freight brokerage TMSHow to create a brokerage order
- Freight brokerage TMSHow to read AR aging and send a customer statement
- Freight brokerage TMSHow to invoice a customer for a brokered load
- Freight brokerage TMSHow to email a customer invoice with the POD attached