Freight brokerage TMS · Documents
Detention in trucking: work it out on a brokered load
On the Desk row's Extra charge, pick Detention and enter when the truck arrived and left, the free hours and the hourly rates for the customer and the carrier. Tezify works out both sides. Inside free time there is no detention.
What detention is
Detention is pay for the time a truck waits at a shipper or receiver past the free time. Two hours free is the common default, then an hourly rate. As a broker you sit in the middle: the carrier asks you for detention, and you bill the customer. The two rates are often different, and your margin on the wait is the gap between them.
How Tezify works it out
- Time on site is from Arrived to Left.
- Free hours come off first. Inside the free time, it says there is no detention.
- What is left is rounded up to the next quarter hour, the way shippers and carriers bill it.
- Billable hours times the customer rate is what the customer pays. Billable hours times the carrier rate is what the carrier is owed.
| Example | Value |
|---|---|
| Arrived and left | 08:00 to 12:10, 4 hours 10 minutes |
| Free time | 2 hours |
| Billable | 2 hours 10 minutes, rounded up to 2.25 hours |
| Customer at $75/h | $168.75 |
| Carrier at $50/h | $112.50 |
Add detention to a load
- On the Desk, open the load's Extra charge and pick Detention.
- Enter the stop's Arrived and Left times from the BOL or the check calls.
- Check Free hours, Customer $/h and Carrier $/h. The form starts at 2 hours, $75 and $50. Change them to match the rate con and the customer contract.
- Read the amounts. You can type over Customer pays or Carrier is owed if you agreed a flat figure.
- Add a note, such as who approved it, and press Add charge. It is billed to the customer and owed to the carrier in one step.
Your detention terms on the rate con
Your rate con prints a detention clause. If you wrote one in rate con wording, that is used. If not, and your company has a detention rate in Settings, it prints that rate and free time, with in and out times on the BOL and payment only when approved in writing. Otherwise it prints the standard clause: call dispatch while on site, times on the BOL, paid only when approved in writing.
When the shortcut says no
- The load already has an invoice. Use the after-invoice route so the customer is billed properly.
- The carrier bill or payment already exists. Review carrier pay first.
- The load is split between carriers. Add the carrier part on the right leg.
- The load is cancelled or TONU.
Common questions
Can I pay the carrier more than I bill the customer?
Yes, for goodwill. Enter both amounts. A charge with zero on both sides is refused.
Does detention show on the invoice?
Yes. Detention evidence shows on Invoicing so you can bill it with the times.
The carrier billed detention without times. What happens?
A carrier bill with detention but no in and out times on the POD is flagged in Carrier Pay, so you can ask for proof before paying.
Ready to do it? This lives at /admin/brokerage in Tezify.
Related articles
- Freight brokerage TMSHow to add detention, lumper and other accessorials
- Freight brokerage TMSHow to approve carrier requests for detention or lumper
- Freight brokerage TMSHow to bill detention or charges after invoicing
- Freight brokerage TMSHow to edit the terms on your rate confirmation
- Freight brokerage TMSHow to upload a POD or BOL on a brokered load
- Freight brokerage TMSHow to chase a missing POD from a carrier