Carrier and trucking TMS · Maintenance

Preventive maintenance for trucks: PM by miles or date

Give each truck a PM interval in miles, days or both. Tezify marks the PM due by whichever comes first, keeps the odometer current from your ELD, and the PM window shows the last day the truck can go in before a booked load gets in the way.

Updated Open this in Tezify

Why PM by miles and by date

Preventive maintenance is the service you do on a schedule, before something breaks: oil, filters, grease, brakes and a once-over by the shop. A truck running hard hits its mile limit first. A truck that sits hits its date first. Tracking both catches each case.

49 CFR 396.3 asks a carrier to inspect, repair and maintain its vehicles and keep records of it. It does not set an interval. You pick one with your shop and the engine maker's schedule.

Set the intervals

  1. Open Equipment, then Maintenance, and find PM intervals.
  2. Enter a fleet default in Fleet miles, Fleet days or both, and press Save fleet default.
  3. For a truck that needs its own schedule, press Edit interval on its row. Use Use fleet default to undo it.
  4. Check the Next PM column. It shows the date, the odometer, or Not set.

The interval that applies is the most specific one: the unit's own, then the fleet default, then the built-in 25,000 miles or 120 days. When a PM is done, by closing the PM work order or with PM done on the row, the next PM moves forward from that interval.

Keep the odometer right

Tezify uses the higher of the ELD odometer and the last manual reading. A stale ELD value cannot hide a truck that is past its PM. Kilometres from the ELD are converted to miles. A manual reading lower than the last one is refused, which stops a typo from pushing the PM out by months.

Find a day to do it

The Maintenance page lists units overdue or due inside 30 days. The PM window panel answers the harder question: when can the truck actually go in? It shows the last day before the PM comes due and the booked load standing in the way. A service is assumed to take one day. A truck with too little mileage history is shown as not enough known, not given a made-up date.

The predictive panel ranks units by how close they are to trouble, so the shop can plan the week instead of reacting to breakdowns.

Common mistakes

  • Setting only a date on a high-mileage truck. It can run thousands of miles past its oil change before the date arrives.
  • Doing the service and not closing the work order. The next PM never moves, and the truck shows overdue.
  • Typing a unit number that does not match the ELD. The ELD odometer then never reaches the unit.

Common questions

Can I schedule reefer PM by engine hours?

Engine hours are stored on the unit, but PM schedules run by miles and date today.

Do trailers get PM too?

Yes. Trailers are units on the same list. Give them a date interval, since most trailers have no odometer feed.

What is the default interval?

25,000 miles or 120 days, whichever comes first, until you set a fleet default or a unit interval.

Where do I record the work itself?

In a work order. See work orders.

Ready to do it? This lives at /admin/maintenance in Tezify.

Open this in Tezify

Still stuck?

Inside Tezify, press the ? at the top of any page to file a ticket with that page attached. Not a customer yet? Ask us anything.