Carrier and trucking TMS · Maintenance

How to create and close a work order

On Maintenance, open a new work order for the unit. Pick the category and priority, enter the shop, parts and labor cost, and close it when the job is done.

Updated Open this in Tezify
  1. Open Equipment, then Maintenance.
  2. Start a work order and pick the unit.
  3. Choose the category: Preventive, Repair, Tire, Inspection, Recall or Fault code.
  4. Set the priority, due date and odometer.
  5. Enter the vendor or shop, parts cost and labor cost.
  6. Save. Press the PDF button to print a work order for the shop.
  7. Close it when the job is done. The close is logged.

Where work orders come from

  • By hand on Maintenance.
  • From a failed DVIR with a critical defect.
  • From a corrective action on Defects and Actions.

Work order costs feed the maintenance line on your P&L. If work orders cannot be read, the P&L holds back net profit instead of showing a wrong figure.

Common questions

Can I sync work orders from Fleetio?

A Fleetio connector is listed under Connections for maintenance data.

Ready to do it? This lives at /admin/maintenance in Tezify.

Open this in Tezify

Still stuck?

Inside Tezify, press the ? at the top of any page to file a ticket with that page attached. Not a customer yet? Ask us anything.