Carrier and trucking TMS · Equipment

How to put a truck out of service and back in

Set the unit's status to out of service on Units or Maintenance. A failed DVIR with a critical defect does it for you. The unit is blocked from loads until it is returned to service.

Updated Open this in Tezify
  1. Open Equipment, then Units, and open the unit.
  2. Change its status to out of service and save. The change is logged.
  3. Fix the problem with a work order.
  4. Close the work order and set the unit back to active.

From a failed inspection

When a driver submits a DVIR with a critical defect, Tezify creates a corrective action and a work order and pulls the unit out of service. If the unit on the report is not on your equipment list, the owner is told it was not pulled, with the unit named.

A later passing DVIR puts the unit back only when no critical defect or work order is still open. A unit you parked by hand with an open critical repair stays parked.

Common questions

Who can set a unit out of service?

Maintenance and the owner can change status. Safety may set a unit out of service only.

Does a roadside out-of-service order park the truck?

Yes. When you log the inspection, tick what the order covers. The truck, trailer or driver is out of service and blocked from dispatch until you clear the order on Roadside inspections.

Ready to do it? This lives at /admin/assets in Tezify.

Open this in Tezify

Still stuck?

Inside Tezify, press the ? at the top of any page to file a ticket with that page attached. Not a customer yet? Ask us anything.